Plextor PX-504A, Installation And User Manual

Page: 12 / 56

Section 1. Getting Started
6
PX-504A Installation and Users Manual
Rear Panel
Figure 2: Rear Panel of the Internal Drive
•
Digital audio output connector: Outputs digital stereo signal. For connecting to
a sound board that supports Sony/Philips Digital Interface (SPDIF) or Digital-In.
•
Analog audio output connector: Outputs analog stereo signal. Use to connect to
sound board or audio amplifier. Use standard MPC-3 type, 4-pin connector.
•
Mode jumper: Use the mode jumper to select operation as an IDE master or
slave, or for cable select. In general, leave this jumper at its factory setting, which
is master.
•
IDE cable connector: Connects to IDE (ATAPI) interface using 40-pin IDE flat
ribbon cable.
•
Power connector: Connects to your computer’s power supply to provide
DC +5 volts and +12 volts to the PX-504A.