7077-801F • 08/20
4
CAUTION
After reading these instructions, if you have any doubt
about your ability to complete your installation in a
professional manner you should obtain the services
of an installer versed in all aspects as to the correct
and safe installation. Do not use temporary makeshift
compromises during installation.
BEFORE INSTALLATION OF YOUR APPLIANCE
1. Check with the building inspector’s office for compliance
with local codes; a permit may be required.
2. Use 3” or 4” (76-102mm) diameter type “L” or “PL”
venting system. It can be vented vertically or horizontally.
Approved adaptors can be used to connect the “L” or”
PL” to approved wood stove venting such as single wall
or double wall venting previously used to vent a wood
burning appliance. INSTALL VENT AT CLEARANCES
SPECIFIED BY THE VENT MANUFACTURE.
3. Always connect this unit to an approved chimney system
and NEVER vent to another room or inside a building.
4. DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST
VENTING SYSTEM OF THIS UNIT.
5. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE
SERVING ANOTHER APPLIANCE.
6. The connector pipe and chimney should be inspected
periodically and cleaned if necessary. Review additional
information located in the maintenance section of this
Owner’s Manual.
7. Remember the clearance distances when you place
furniture or other objects within the area. This includes
heat sensitive materials such as candles, seasonal
decorations or draperies. DO NOT STORE WOOD,
FLAMMABLE LIQUIDS OR OTHER COMBUSTIBLE
MATERIALS TOO CLOSE TO THE UNIT.
8. Be aware of the required clearances when locating the
unit. Refer to the label on the rear of the unit for required
clearances.
9. Contact your local municipal or provincial fire authority
for information of how to handle a chimney fire. Have a
clear understood plan to handle a chimney fire. In the
event of a chimney fire, CALL THE FIRE DEPARTMENT.
10. Prior to burning the unit for the first time make sure the
hardware kit has been removed from the firebox.
IMPORTANT
It is highly recommended that the pellet heater and
chimney be installed by a qualified installer. A qualified
installer is a person or entity who regularly installs solid
burning fuel products and chimneys in the course of their
ordinary business.
Hot glass will cause burns.
•
Do not touch glass until it is cooled
•
NEVER allow children to touch glass
•
Keep children away
•
CAREFULLY SUPERVISE children in same room
as fireplace.
•
Alert children and adults to hazards of high
temperatures.
• High temperatures may ignite clothing or other
flammable materials.
•
Keep clothing, furniture, draperies and other
flammable materials away.
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
If the information in these instructions is not
followed exactly, a fire may result causing
property damage, personal injury, or death.
•
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
•
Do not over fire - If heater or chimney connector glows,
you are over firing. Over firing will void your warranty.
•
Comply with all minimum clearances to combustibles
as specified.
Failure to comply may cause house fire.
WARNING
!
WARNING
!
Fire Risk.
Tested and approved for wood pellets. Burning
of any over type of fuel will void your warranty.
WARNING
!
