10
GB/IE
• Please note that the article may heat up in
strong sunlight.
• No technical modifications may be made to the
article.
Swing assembly
Select a horizontal and level area with sufficient
space in order to assemble the article.
1. Lay the nest swing (1) spread out on the floor.
Feed the four side reinforcements (2) through
the tabs on the edge of the nest swing. When
inserting the side reinforcements please ensure
that a thin end is pointing towards a wide end.
Insert the four side reinforcements into one
another.
The drill holes on each of the two side
reinforcements must be exactly above one
another (figure B).
2. Release the pre-assembled nuts on the
mountings (3) and remove them together with
one washer. Insert one hook with the remaining
washer through a drill hole from above. Add
the second washer from below.
Lock the hook with a nut on each (figure C).
Only attach the swing to installations for which
you can guarantee sufficient stability with absolute
certainty. Use at least 10mm thick screw hooks for
the assembly that are bent through at least 540°
or completely closed in order to prevent unintenti-
onal release. On wooden beams the attachment
must be inserted through all the wood and locked
from above in order to achieve a sufficiently
secure connection.
Different attachment hooks
Only attach the swing element to a suitable moun-
ting. These are:
No. 1: a closed mounting eye that is attached to
the swing element using a snap hook (figure D).
No. 2: a round hook that is bent through 540° in
order to prevent unintentional release (figure E).
Note! The eye on the mounting eye (1)
must be attached transverse to the swing
direction so that the attachment element
of the swing is not damaged too badly
during use.
Setting the height of the swing
element
The height of the seat can be set using the ring on
the upper end of the swing. Once you have set the
length of the rope it will tighten itself when load is
placed on the swing (figure F). Set the length on
both sides in such a way that the swing is absolu-
tely horizontal.
Care, storage
Please never forget that regular maintenance and
cleaning contribute to the safety and preservation
of the article.
Always store the swing elements and the seesaw
in clean and dry condition and in a temperature-
controlled room.
IMPORTANT! Only clean the article with water,
never with aggressive agents. Then wipe the
article dry with a cleaning cloth.
Disposal
Dispose of the article and the packaging materials
in accordance with current local regulations.
Packaging materials such as foil bags are not sui-
table to be given to children. Keep the packaging
materials out of the reach of children.
3-year warranty
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and work-
manship and does not apply to misuse or impro-
per handling. Your statutory rights, especially the
warranty rights, are not affected by this warranty.
With regard to complaints, please contact the fol-
lowing service hotline or contact us by e-mail. Our
service employees will advise as to the subsequent
procedure as quickly as possible. We will be per-
sonally available to discuss the situation with you.
Any repairs under the warranty, statutory gua-
rantees or through goodwill do not extend the
warranty period. This also applies to replaced
and repaired parts. Repairs after the warranty are
subject to a charge.
