6
TEMPLATE and DRILLING INSTRUCTIONS
If you have a
Z|,
" drill bit/countersink tool, set the drill bit depth
to the thickness of the board.
(Fig. 1)
Drill locations as marked.
Warning: Do not countersink
deeper than the depth
of the screw head.
In the assembly instructions, you will be asked to attach the
countersunk and predrilled boards with #8 x
2Z|x
" deck screws.
To make this process easier, use
the predrilled boards as templates
for drilling pilot holes into the
second boards.
(Fig. 2)
Note: A second drill will make
this process easier by eliminating
multiple changes between drill bit
and counersink bit.
ADJUST
Your building kit includes a
Drill Template
to help you create some of the pilot holes
needed to build your playset.
Position the template and mark only the
holes that need to be drilled according to
the patterns shown below. Remove the
template.
Warning: Do not drill holes through
the template as you may damage the
template.
(Fig. 1)
PLEASE NOTE: Letters represent pattern not position
Note: When the PlayStar logo is showing, the three tabs on the bottom will position the template square
with any two edges. When the arrow is showing, the two tabs on the bottom will position the template
square with one edge only, which will allow you to slide the template anywhere along the board.
J
H
H
D
E
B-ALT
C-ALT
F
A
C
A
C
B
B
B-R
ev
B-R
ev
G
G
1" x 4" or
2" x 4"
2" x 4"
Actual Size Template
TEMPLATE FOR DRILL HOLES
The rigid version of the template like the one
shown here can be found inside your kit.
ADJUST
(Fig. 2)
