For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
GEO-WAVE CLIMBER HORIZONTAL
Rev C
1249-DDH \-DGH
Page 4 of 6
Figure 1.3
1/2" x 1-1/2"
Button Head Bolt
.
For Deck to Ground Mount Only
shown in Figure 1.3. (See Note A)
Loosely attach Geo-Wave Climber Legs to climber as
CLIMBER LEG
GEO-WAVE
Step 6
1/2" x 1-3/8"
O.D. Washer
Figure 1.4
Step 8
Fully tighten all fasteners according to the
"TIGHTENING TORQUE FOR HARDWARE" Section
of the Installation Manual.
Step 9
For Deck to Ground Mount Only.
Plumb and level entire component. Pour concrete
into footing hole. Allow at least 72 hours to cure
before using this equipment. (See Note B.)
Step 10
Place appropriate compliant protective surfacing
under and around Geo-Wave Climber. (See Note D.)
1/2" x 1-3/8"
O.D. Washer
DECK MOUNT
BRACKET
Place climber in between decks and attach to Deck Mount
For Deck to Deck Mount:
Deck to Deck Mount and Note A)
Brackets as shown in Figure 1.4. (Refer to Side Elevation -
CLIMBER
GEO-WAVE
In Insert
1/2" Molded
Step 7
For Deck to Ground Mount:
Place climber and legs into footing holes and attach to Deck
Mount Brackets as shown in Figure 1.4. (Refer to Side
Elevation - Deck to Ground Mount and Note A)
1/2" x 1-1/2"
Button Head Bolt
