3. Set the expansion anchor at the bottom of the anchor hole by tapping the anchor pin with
the supplied ¼” diameter set tool rod with a hammer.
4. Locate a bonding source to bond (ground) the anchor. The steel rebar-bonding grid of the
pool deck is the best choice for bonding the anchor. Spectrum recommends using a bonding
strip to connect the anchor to one of the anchor bolts. Ensure that bonding meets all state
and local requirements.
NOTE:
Article 680 of the National Electrical Code requires bonding of all metallic components in
relationship to pools and spas.
Lift Assembly
1. Attach the Lifting Cylinder to the Seat arm using a 3/8" x 3" Button Head screw, two 3/8" flat
washers, one 3/8" lock washer and a 3/8" acorn nut.
2. Attach the Rotationally molded Seat halves to the Seat arm using eight 5/16" x 1" Button
head screws, 5/16" washers and 5/16" lock washers. Make sure to attach the seatbelt using
the rear holes on the bottom seat half.
3. Connect footrest using one button head socket screw 1/4" x 1/2" and one 1/4" lock washer.
4. Place the two armrests into the seat frame behind the seat back, if the armrests do not look
parallel to the plane of the seat, switch them.
5. Connect the water supply to the female garden hose coupling on the control valve. Cut the
exhaust line to length making sure it is plumbed to an appropriate drain. After purging the
air from the cylinder, the Summit Lift is ready for operation.
.
4
800.791.8056
▪ www.spectrumproducts.com
