7
800.791.8056
▪ www.spectrumproducts.com
g.
The below image shows the proper way to assemble the seat belt.
h.
Attach the other seat half to the back rest mounting plate using:
4 - 5/16"-
18 x ¾”
4 - 5/16" Flat Washers
4 - 5/16" Lock Washers
i.
Attach the footrest to the seat arm assembly using:
1 - 3/8"
– Hex Bolt 2”
1 - 3/8" Flat Washers
1 - 3/8" Nylock Nut
Tighten the bolt until the flat washers are snug, and then back off until the Footrest pivots freely.
Adjust footrest to desired height using installed 3/8" - Button Head Bolt.
j.
Tighten the anchor locking bolt by access through a hole one inch up from the top of the
anchor on deck. The included 7/32 Allen wrench will fit a 3/8” button head internal to the
mast. This internal fastener is at an angle and can be tightened down until there is no lift
movement in the anchor. The figure above shows the location and approximate angle of
the anchor locking mechanism for the lift.
k.
Test the lift for proper operation.
