5
800.791.8056
▪ www.spectrumproducts.com
Allow the concrete to cure for at least 7-days before installing and using the lift.
Assembly Instruction
The following tools will be required to complete assembly and installation of the lift:
-
9/16” ratchet and open-end wrench
-
5/8” ratchet and open end wrench
-
1/2” ratchet or open-end wrench
-
3/16” hex key (allen wrench)
Lift Assembly
a.
Fully charge lift battery.
b.
Stand the mast assembly up in the anchor that is installed in the pool/spa deck
c.
Attach the actuator end fitting to the lifting arms using:
1
– 7/16” x 1 3/4” Hex cap bolt
1 -
7/16” Nylock nut
d.
Tilt the battery into the Receiver until it locks into place.
e.
Test lift operation by pushing the up and down toggle switch on the handset to ensure
the lift is operational (See page 8 for instructions on using handset). Then run the
actuator into the fully extended position by pressing the up button until the actuator stops
moving. Leave the lift in this position for the next steps.
f.
Join the seat arm to the mast assembly using:
2 -
3/8” Shoulder 2 1/2” x 5/16” Thread
4 -
3/8” Flat washers
2 -
5/16” - 16 Nylock nut
2 - Donut Shims
