MPS-6 User Manual
14
CHANGING THE FUSE ON THE MPS-6
Inside the power connector on the rear panel of the MPS-6 are two fuses that protect the machine from
dangerous power surges. If the machine fails to power up or no light on the front panel is lit after pressing the
standby power button on the front panel then proceed as follows to change the fuses:
1. Locate fuse compartment on power connector on rear panel:
2. Use a small flat screw driver to pry open the fuse compartment as shown in above picture.
3. Pull fuse compartment out and flip sideways as shown below:
4. Replace both fuses with 1.6A / 250V slow blow types. Length is 20mm
CLEANING THE CHASSIS OF THE MPS-6
It is possible that the chassis can stain slightly from finger prints or you may discover subtle stains on the
surface after some use. You can easily clean the chassis with a window cleaning solution and a clean and
soft cloth. The best way is with a micro fiber cloth.
Fuse compartment
Prying open with small screw driver
