Playback Designs MPS-6, User Manual

Page: 8 / 20

MPS-6 User Manual
8
REMOTE CONTROL UNIT
DISC
MUTE
DAC PRE
PHSE
DIM
LAYR
TIME
MUTE
VOL +/-
Opens the settings menu on front panel. Press the DISC button first
to select the MPS-8 settings.
During normal operation these up and down arrows directly below the
DISC button toggle through the active inputs of the MPS-8.
During settings display these buttons toggle through the settings
menu.
Open / close tray.
Inverts the phase on both analog outputs.
Dims the display on front panel.
If these buttons are pressed for less than 1 second they allow you to
jump tracks in sequential order. If during normal playback they are
held for more than 1 second the player enters Scan Mode and fast
forwards or fast reverses while the button is being pressed.
Stops the transport.
Starts playback. Can also be used to close the tray and immediately
start playback.
Pauses playback. Press the play button to continue playback.
This toggles the layer selection for SACD discs. In order to change
the layer the player must be stopped. The first time this button is
pressed the current layer is displayed. Each subsequent press of the
button will pre-select another layer. If then the button is not pressed
for more than one second the player will switch to the chosen layer if
available. This has no effect for CD’s.
This toggles the time display during playback between two states:

Elapsed time

Remaining time on active track
The first time this button is pressed it will indicate the currently
selected state without changing it. If during the next 5 seconds the
button is pressed again it will toggle to the next state.
This toggles through two Repeat modes: Repeat currently playing
track or Repeat entire disc.
Numeric buttons:
Pressing any numeric button with a single digit will locate the
transport to the beginning of the chosen track and start playback.
The +10 button can be used to access tracks higher than 9. For
instance, track 23 can be accessed by pressing: +10 and +10 again
and then 3.
Mutes all analog outputs.
Analog output volume control. Need to enable variable output level
(see settings menu).