IPS-3 User Manual
15
CHANGING THE FUSE ON THE IPS-3
Inside the power connector on the rear panel of the IPS-3 is a fuse that protects the system from dangerous
power surges. If the system fails to power up or no light on the front panel is lit then proceed as follows to
change the fuse:
1. Locate fuse compartment on power connector on
rear panel.
2. Use a small screw driver to pry open the fuse
holder.
3. The fuse holder contains 2 fuses. The top one is a
spare and can replace the blown one at the bottom.
4. Replace fuse holder into power connector by
making sure that good fuse is at bottom.
Replacement fuses should be rated:
6.3A / 230V slow blow, 20mm, for 110V operation
3A / 230V slow blow, 20mm, for 230V operation
Fuse compartment
