Platinum Hot Tubs Platinum II, Owner'S Manual

Page: 13 / 26

START-UP INSTRUCTIONS
FOR BEST RESULTS, READ EACH STEP IN ITS ENTIRELY BEFORE PROCEEDING WITH STEP.
FILLING THE SPA
Clear all debris from the inside of the spa. At the factory your spa shell was cleaned and polished, but you may want to treat it with a
specially formulated spa cleaner available by phone 1-800-749-8003. Make sure the spa has been installed correctly, including
electrical wiring connections as specified in the wiring diagram, and the spa is level.
Do Not Over Fill
. Never fill your spa with water from a water softener, or use hot water while filling. Ensure that your spa drain is
shut off. Remove your filter lid. Place your garden hose into the filter housing and begin filling with clean water. Continue filling spa
until the water level is 2 inches above the highest water jet. Remember every person entering a spa displaces a given bolume of water,
so
adjust water level to number of people who will be entering spa
. If your water is extremely “hard”, it is preferable to fill
halfway with hard water and the rest of the way with softened water. Or, you may fill the entire spa with hard water if you use a
special water additive available by phone 1-800-749-8803.
Always refill spa through one filter housing to purge any trapped air from pump intakes. Failure to do so may cause air to be trapped
in the circulation pumps intake creating an air lock, preventing the pump from circulating water. Ensure both side valves are fully
open see figure 5 (Page 6). Make sure filter cartridge is clean before installing. See “Cleaning the Filter” for specific cleaning
procedures (see page 13).
Remove the hose and re-install filter lid. (Figure 6)
7
Figure 6
Weir Door Filter
Control Panel
Waterfall
Speaker
Speaker
Air Control
Air Control
Waterfall
Control
Aromatherapy
Air Control
Led Light
Pillow
Pillow
Pillow
Pillow
Air Control
Filter Lid
Figure 7
Dual Cartridge Filters
Diverter Valve
Audio Remote
Control