26
recording.
Push recording button to stop recording or push playing button to stop playing or exit from
system setup menu, then turn off the power.
If do not use the video recorder for a long time, should pull out the power line from the
electrical outlet.
6.3 Normal Recording
Connect the power to all related equipments; ensure that there is video input.
Push display button to check spare space of the hard disk, if there is no much space, please
think whether to change hard disk first or select overwriting modes.
Check recording parameter setup before recording; select video quality, frame rate. You cannot
change record setting during the process of recording,
Manual recordings belong to normal recording. Under the manual mode (non-schedule status),
here pushing record button will record all channels video.
Push the record button to begin recording, sixteen channels will start simultaneously recording.
While in normal recording mode, push record button, and enter the right password, it will stop
recording.
During the process of recording, if the hard disk is full, and the system is set to automatic
overwrite, then the recording will not be interrupted, and it begins to overwrite the earliest
recorded area; if the system is set to overwrite disable, it will stop recording.
6.4 Alarm Recording
Alarm recording is not started by manually pushing record button, the entire recording started by
manually pushing the record button are normal record.
Alarm recording can be activated by alarm input signal or motion, so it must to check whether the
connection of alarm input equipment is correct, stable and reliable, and the alarm set is right,
please refer to sensor setup.
The prerequisite condition of whether the alarm recording can be activated by exterior input signal
or the motion is that the system must be set on schedule, also, in the menu of alarm setup, for
exterior input alarm, alarm enable of that channel must set to ON , for motion alarm, motion
enable of that channel must set ON , and set the right area for motion detect.
Under the state of off-schedule, system will never start alarm recording. Setting schedule on or off
is achieved through pushing the schedule button on the front panel, but not through system setup
menu and window. Under schedule-on situation, the character S will display on the screen,
Alarm video recording cannot stop by pushing record button, but can stop by removing schedule.
Because once the system is set on schedule, the schedule cannot be removed randomly, so there
is a password protection to remove schedule, only after inputting correct password, you can take
schedule off.
Check alarm recording setup before recording; confirm the video quality and the frame rate, the
