2
Sun Lounge Assembly Instructions
Introduction
Congratulations on purchasing an Sun Lounge. We are certain that it will give you many happy years of
pleasure in your garden.
Sun Lounge has been designed to be as easy to put together as it is beautiful to look at. Most of the work can be
done by a single person. Only attaching the roof requires the help of a family member or neighbor for a short
while.
Easy assembly methods eliminate the need for tools or special
expertise.
Connect the specified parts.
Match the holes in the profiles and the connectors. Place a
pin on the pin tool and push the pin through the lined-up
holes to lock the parts in place. Many connections require
pins on both sides.
Note:
Extra pins are included.
If you wish to disassemble the parts at any time, remove the
pins using the pin tool. Place the end into the exposed hole
and lever the pin out.
If a hole in the connector is missing, drill a hole with a 6 mm
(¼") drill bit through the assembled profile and then insert the
pin.
In extremely rare cases connectors will not slip into some
round or oval profiles. In this case place the affected part into
10 cm (4”) of boiling water for 15 seconds before connecting.
Important:
In order to maintain the life of your
greenhouse, it is essential to insert glazing elements fully
and completely.
Moisten the glazing element with soapy water.
Insert one end of the glazing element into the profile until it
snaps into place.
Push the glazing element along its length.
Continue until the end of the glazing element snaps in place.
The callout (
) shows an enlarged cross-section of the profile and glazing element when it is seated correctly
The panels in your RionSun Lounge are protected by a special plastic film that must be removed before
installation. Depending on the type of panels included in the model you have ordered, follow the instructions
below:
Note:
In some models profiles have identification stickers. We recommend removing them as you work.
Sun Lounge assembly is done in the following steps:
Prepare a Foundation for Your Sun Lounge (page 3)
Identify Sun Lounge Parts (page 4)
Prepare Your Parts for Assembly (page 6)
Lay Out The Sun Lounge Frame (page 7)
Secure the Frame to Foundation (page 8)
Assemble the Sun Lounge Pediments (page 9)
Assemble the Roof Framework (page 11)
Prepare the Roof for Panels (page 12)
Raise the Sun Lounge Roof (page 13)
Secure Sun Lounge to the Wall (page 15)
Assemble the Door (Left Entrance Option) (page 20)
Attach the Door (Left Entrance Option) (page 21)
Assemble the Door (Right Entrance Option) (page 22)
Attach the Door (Right Entrance Option) (page 23)
Polycarbonate Panels
Acrylic Panels
Polycarbonate panels have plastic film indicating the outside for UV
protection. Remove the plastic film as the panels are installed to be sure
that the UV protection faces the correct side.
Acrylic panels are protected by
plastic film on both sides. Remove
the plastic before installation.
Summary of Contents for Rion Sun Lounge
Page 27: ...25 Notes...
