10
Sun Lounge Assembly Instructions
For
Sun Lounge
with Right Entrance
Put the connectors and profiles of the top triangular window of the doorway pediment together except for
the 6A pediment connector.
Remove the plastic film from the PN52L pediment panel and put it in place.
Note:
If your model includes polycarbonate panels with UV protection, there is a single plastic film indicating
the outside. Acrylic panels are protected by plastic film on both sides.
Remove the plastic before installation.
Slide the 6A pediment connector in place. Take advantage of the flexibility of the profiles.
Attach the Door11 sliding track with AS80 screws and wing nuts through the connectors where shown.
Lock the parts in place using pins.
Attach the E13 profile and the 09 connector to the doorway pediment.
Attach a R10 and two E2 profiles to a 3A pediment rib connector and put them loosely in place.
Remove the plastic film from the PN51L side panel. Make sure that the proper side faces out, and put the
panel in place. Lock all connectors and profiles in place with pins and set the doorway pediment aside.
Put the connectors and profiles of the top triangular window of the rear pediment together except for the 7A
pediment connector.
Remove the plastic film from the PN52R pediment panel and put it in place.
Slide the 7A pediment connector in place. Take advantage of the flexibility of the profiles. Lock the parts in
place with pins.
Put the R10 and three E2 profiles and 4A connector loosely in place.
Remove the plastic film from the PN51R panel. Put the panel in place and lock the parts together with pins.
Place a B12 and E2 profile in place and connect them loosely with a 2D connector.
Remove the plastic film from the PN53 panel, put it where shown, and lock the parts in place using pins.
Summary of Contents for Rion Sun Lounge
Page 27: ...25 Notes...
