PLASMATECH SHARK 155, Operator'S Manual

Page: 16 / 58

16
90°
FIG. M
FIG. L
electrode
air diffuser
nozzle
outer nozzle holder
outer nozzle holder
with Ohmic sensor
Shield
CONSUMABLES FOR AUTOMATIC CUTTING
Figure I shows the consumables used for the plasma torches
supplied, complete with the CEA order codes.
FITTING CONSUMABLES ON THE TORCH FOR
AUTOMATIC CUTTING
WARNING: Before changing consumables, check that the ma-
chine’s main switch is in the O position.
To use the torch for automatic cutting, a complete set of con-
sumables must be fitted, as shown in figure L. An outside noz-
zle holder is available with an Ohmic sensor, which is to be
used with shielded consumables.
EQUIPPING THE TORCH FOR AUTOMATIC CUTTING
The SKM series of torches for automatic cutting can be fitted on
a wide range of X-Y-Z benches, motorised equipments, bevel-
lers for tubes, and other equipment. Install the torch according
to the manufacturer’s instructions.
Fit the SKM torch perpendicular to the plate, to achieve a verti-
cal cut. Use a square to align the torch at 90° (Fig. M).
105-160A
105-160A
45-85A
105-160A
45-85A
45-85A
105A
45A
125A
65A
160A
85A
45-85 A
105-160 A
SKM 165
487637 425024 482137
486021
486023
408642
408641
408640
487638 425024 482137
486022
486024
408645
408644
408643
FIG. I