![background image](http://html1.mh-extra.com/html/plantronics/poly-medialign-65/poly-medialign-65_installation-manual_1565627150.webp)
Setting Up the Poly Medialign Dual Display System
Poly, Inc.
150
i
Keeping the cables routed toward the center of the frame, place the EagleEye Director II base
assembly on top of the left display. Secure it to the display using three M5 × 10mm screws.
j
Refer to the
Polycom EagleEye Director II Setup Sheet
to complete the EagleEye Director II
assembly.
7
Cable the Medialign 86D system.
a
Connect the HDCI cable to the codec.
b
Connect the 3.5mm to 2x RCA-F Y-adapter cable to the codec audio out.
c
Connect the camera audio cable RCA-M connectors to the Y-adapter, red to red and white to
white.
d
Connect the RCA cable for the left speaker to the camera audio cable white RCA-F.
e
Route the RCA cable for the right speaker across the frames and through the cable clips. Connect
it to the camera audio cable red RCA-F.
f
Apply a ferrite bead to one end of the 2M HDMI cable. Connect that end of the cable to the left
display HDMI 1 input and the codec primary HDMI output.
g
Apply a ferrite bead to one end of the 4M HDMI cable. Connect that end of the cable to the right
display HDMI 1 input. Route it along the frames, through the cable clips, and connect it to the
codec secondary display output.
h
Place the speaker power adapter in the lower rail of the lower horizontal frame toward the right
side of the left frame assembly.
(3) M5 x 10mm SCREW
1601-12997-001
FRAME NOT SHOWN