Prostyle Intra X-ray Unit 25
ERROR CODES
User's manual
13
ERROR CODES
ERROR CODE
ERROR MESSAGE EXPLANATION
E . 0 0
Exposure key was released too early during the exposure.
E . 1 0
X-ray tube Anode voltage (kV) overshoot.
E . 11
X-ray tube Anode voltage (kV) dropped suddenly.
E . 1 2
X-ray tube cathode filament preheating voltages are not calibrated.
E . 1 3
Filament preheating voltage calibration failed.
E . 2 9
Membrane keyboard key short-circuited/pressed during the self test or
faulty display board.
E . 3 0
kV value does not reach or it exceeds the given value (difference more than
5%).
E . 3 1
X-ray tube Anode current (mA) missing, or not in specified limits.
E . 3 3
X-ray tube Filament voltage (V) missing, or outside the range (too low or
too high).
E . 3 4
X-ray tube Anode voltage (kV) missing, or below the specified limit.
E . 3 6
Too long exposure.
E . 3 7
kV feedback signal open circuit or short circuit.
E . 3 8
mA feedback signal open circuit or short circuit.
E . 5 0
Tube head temperature sensor short circuit.
E . 5 1
Tube head temperature sensor open circuit.
E . 5 2
Filament voltage feedback not in specified limits.
E . 5 7
Exposure key pressed during self test.
E . 6 0
± 15VDC voltage is out of limits.
E . 6 1
Communication error between Display and Tube head CPU.
E . 7 1
FLASH memory check-sum error (Tube head CPU).
E . 8 1
EEPROM memory defective (Tube head CPU).
E . 8 3
Config register error (Tube head CPU).
