Planmeca Proline XC Panoramic, Calibration Manual, Page: 18 / 58

- 18 -
2.1.a Network Interface Box Connections (Figure 23)
1. Crossover Cable (has red end caps)
2. Y-connector, dongle
3. CAT-5 cable (port 1)
4. Power cable
1 2 3 4
2.1.b Didapi Configuration
Click Start, Click All Programs and select Planmeca, then
select Didapi Configuration.
Click on Ethernet Interface.
The default ip address is 192.168.0.135
Click on Proline which will open Windows Notepad. Put the
below in:
localhost=(ip address):5120/1
Save the file and click refresh. Close Didapi Configuration.
2.2 Setting up Beam Check
Press the
i icon on the lower hand corner of the touch screen. (Figure 24)
Figure 24