◆
NetWare
◆
To configure the print server under this networking OS, you need to use
the Auto Setup or Manual Setup option in the Smart Print Manager 2
utility.
The print server does not support NetWare 4.X/5.X NDS Mode. If
NDS Mode is in use now, switch to Bindery Mode before configuring the
print server and creating a print queue. For more information on the two
modes, refer to your NetWare manual.
Using Auto Setup under Windows95/98 to initiate automatic
confinstallation
1. Refer to Chapter 2 to setup the Mini300hardware.
2. Refer to Section 3-1 in Chapter 3 and install
“
Smart Print Manager 2
”
to the PC you wish to configure. (It is NOT necessary to install this
utility to all PCs.)
3. See Section 4-1-b in Chapter 4 to verify that IPX/SPX protocol has
been properly installed.
4. Refer to Section 5-4-a in Chapter 5 and use the Auto Setup option in
Smart Print Manger 2 to configure the print server.
5. See Section 5-4-c in Chapter 5 to configure each client PC.
Using TCP/IP Protocol with LPR Port
1. Refer to Chapter 2 and setup the Mini300hardware.
2. Refer to Section 4-2-c in Chapter 4 to verify that TCP/IP protocol has
been properly installed. If you plan to use the Smart Print Manager 2
utility, also refer to Section 4-2-b to verify that IPX/SPX protocol has
been installed. (Note: the IPX/SPX protocol is required to use Smart
Print Manager 2. After you have made necessary changes to the print
server via the utility, you can delete the protocol. This protocol is not
required if you plan to use a Web browser to configure the print server.)
3. Refer to Chapter 4 to assign an IP address to the Mini300 print server.
If you are using Smart Print Manager 2, proceed to Section 4-3-a. Or
go to Section 4-3-b if you wish to use your Web browser to configure
the print server.
4. See Section 5-2-d in Chapter 5 to make necessary changes to the
existing printing environment.
Summary of Contents for Mini300
Page 2: ......
