User Manual of WNAP-6315
-53-
The page includes the following fields:
Object
Description
Fragment Threshold
You can specify the maximum size of packet during the fragmentation
of data to be transmitted. If you set this value too low, it will result in
bad performance.
Default is “2346”.
RTS Threshold
When the packet size is smaller than the RTS threshold, the access
point will not use the RTS/CTS mechanism to send this packet.
Default is “2347”.
Beacon Interval
The interval of time that this access point broadcasts a beacon.
Beacon is used to synchronize the wireless network. Default is “100”.
Preamble Type
Preamble type defines the length of CRC block in the frames during
the wireless communication. “
Short Preamble
” is suitable for high
traffic wireless network. “
Long Preamble
” can provide more reliable
communication. Default is “Long Preamble”.
Antenna
Choose
“External”
to switch the antenna to external antenna.
※
For External Antenna Mode, user MUST physically attach antenna
before powering on. Then, configure the Antenna Switch (Wireless
Advanced page) from “
Internal
” to “
External
”.
Default is “Internal”.
IAPP
IAPP (Inter-Access Point Protocol)
enabled is recommended as it
describes an optional extension to IEEE 802.11 that provides wireless
access-point communications among multivendor systems.
Default is “Enabled”.
Protection
Enables a backward compatible protection mechanism for 802.11b
clients. When the protection mode is enabled can slow the throughput
of the 802.11g/n clients by as much as 50%.
Default is “Disabled”.
Aggregation
It is a function where the values of multiple rows are grouped together.
Default is “Enabled”
Short GI
It is used to set the time that the receiver waits for RF reflections to
settle out before sampling data.
Default is “Enabled”
WLAN Partition
This feature also called “
WLAN isolation
” or “
Block Relay
”. If this is
enabled, wireless clients cannot exchange data through the
WNAP-6315.
Default is “Disabled”.
STBC
Activate
Space Time Blocking Code (STBC)
which does not need
channel statement information (CSI).
Default Setting: "Enabled"
LDPC
Low-density Parity-check Code is wireless data transmit algorithm.
Default Setting: "Enabled"
20/40MHz Coexist
Configure 20/40MHz coexisting scheme.
If you set up as "Enabled", "20MHz" and "40MHz" will coexist.