Planet ICA-HM136, User Manual

Page: 49 / 72

Motion Detection
IP CAMERA allows 3 areas motion detection. When motion is
triggered, it can send the video to some specific mail addresses,
transmit the video to remote ftp server, trigger the relay, and
save video to local SD card. To set up the motion area, click
“Area Setting”. Using mouse to drag and draw the area. The
same operation for area 2 and 3.
Record File Setting
IP CAMERA allows 3 different types of recording file to change
its record size. When motion/alarm is triggered, there are 3
different types of record mode.
(1)AVI File (With Record File Setting )
(2)Multi-JPEG (With Record File Setting), only with JPEG
compression format.
(3)Single JPEG (Single File with Interval Setting)
Record Time Setting
Pre Alarm and Post Alarm setups for video start and end time
when motion detected, I/O, or other devices got triggered.
Note: Pre/Post Alarm record time is base on record time setting
and IP Cam built-in Ram memory. Limited by IP Cam built-in
Ram Memory, When information is too much or video quality set
too high, it will cause recording frame drop or decrease on post
alarm recording time.
Network Disconnected
When the network is down, it will save the video to local SD
card.
Note: This function is only enabled in wire connection.
Network IP check
When the connection is down, it records the video to SD card.
Make sure the video recording is continuous. To use this
function, key in the IP address of the PC which has recording
software installed. Enable the function of “Save to SD card”,
then click “Apply”.
Note: The interval of two video files on SD card is fixed with 30
seconds.
5.4.2 Schedule
Schedule
After complete the schedule setup, the camera data will be
recorded according to the schedule setup.
Snapshot
After enable the snapshot function, user can select the storage
position of snapshot file, the interval time of snapshot and the
reserved file name of snapshot.
49