Planet ENW-1281, User Manual, Page: 13 / 52

10
§
If the maximum speed you selected is not listed above, the system will
automatically adapt the V.110 user rate to the default setting at 38400
bps.
8. Enter the ISDN phone number of the remote party that you want to call.
9. Click “ Next ”, and click “ Finish ” to complete the setting.
Making V.120 Connections
1. Execute “ Config ” in “ Configuration Utility ”.
2. Select COM Port Setting tab. Select “ V.120 ” for “ B-Channel protocol ”
in “ 1
st
COM port setting ”.
3. Go to My Computer . Make sure “ Dial-Up Networking ” (DUN) is well
installed.
4. Double-click Make New Connection .
5. Name the new connection appropriately. For example, “V.120”.
6. Select “ Intelligent PCMCIA ISDN TA (modem) ” in the “ Select a
device ” box.
7. Click “ Configure ” button, and give the appropriate settings. Ignore the
“ Maximum speed ” setting (but you are still recommended to set to the
speed at higher than 64000 bps, such as 115200 or higher). Click “ Next ”.
8. Enter the ISDN phone number of the remote party that you want to call.
9. Click “ Next ”, and click “ Finish ” to complete the setting.
Making Multi-destination Connections
The Intelligent ISDN TA PC Card enables the connections between the
different destinations with two different protocols at the same time. For
example, you can separately and independently use one ISDN B-Channel (say
B1-Channel) with PPP protocol to connect to ISP, and the other B-Channel
(say B2-Channel) with V.110 or V.120 to connect to the corporate network in
head quarter or branches. This feature lets the ISDN TA PC Card fully utilize
the ISDN two B-Channel resources.
1. Set up the PPP connection for the first application. Refer to the “ PPP
Connection (method 1) ” section for setting details.
2. Set up the second application, for example, V.120: