Planet ENW-1281, User Manual, Page: 12 / 52

9
Making Multilink PPP Connections
The Intelligent ISDN TA PC Card supports the combining of two 64 Kbps
data channels into the equivalent of a single 128 Kbps line, which is known as
Multi-Link connection. To make the multilink PPP connections, firstly the
PPP connection has to be completed, and the hardware (the ISDN TA PC
Card) has been properly installed. Perform the following steps to proceed.
1. Go to the Start menu. Point to Program . Select Configuration Utility .
Execute CONFIG .
2. Open “ General ” tab. Click “ MP Enabled ” in “ PPP Setting ”.
3. Apply the other settings, “ BOD Enabled ” and “ Second Phone No .” if
available.
Making V.110 Connections
1. Execute “ Config ” in Configuration Utility .
2. Select the COM Port Setting tab. Select “ V.110 ” for “ B-Channel
protocol ” in “ 1
st
COM port setting ”.
3. Make sure Dial-Up Networking is well installed.
4. Double-click “ Make New Connection ”.
5. Name the new connection appropriately. For example, “V.110”.
6. Select “ Intelligent PCMCIA ISDN TA (modem) ” in the “ Select a
device ” box.
7. Click Configure , and specify the V.110 user rate in the Maximum speed
box. Click Next .
Maximum speed=1200 V.110 user rate = 1200 bps.
Maximum speed=2400 V.110 user rate = 2400 bps.
Maximum speed=4800 V.110 user rate = 4800 bps.
Maximum speed=9600 V.110 user rate = 9600 bps.
Maximum speed=19200 V.110 user rate = 19200 bps.
Maximum speed=38400 V.110 user rate = 38400 bps.
Maximum speed=57600 V.110 user rate = 57600 bps*
* Available only for Japan