The following table describes the parameters and buttons of this page:
Field
Description
Enable
Select it to use static IP routes.
Destination
Enter the IP address of the destination device.
Subnet Mask
Enter the subnet mask of the destination device.
Next Hop
the destination device.
Enter the IP address of the next hop in the IP route to
Metric
The metric cost for the destination.
Interface
The interface for the specified route.
Add Route
Click it to add the new static route to the
Static Route
Table
.
Update
parameters. Then click it to save the settings
temporarily.
Select a row in the
Static Route Table
and
modify the
Delete Selected
Select a row in the
Static Route Table
and click it
to
delete the row.
Show Routes
Click it, the
IP Route Table
appears. You can view a list
of destination routes commonly accessed by your
network.
Static Route Table A list of the previously configured static IP routes.
Click
Show Routes
, the page shown in the following figure appears. The table shows a
list of destination routes commonly accessed by your network.
3.6.2.2 RIP
Click
RIP
in the left pane, the page shown in
this device as a RIP-enabled router to communicate with others using Routing Information
Protocol (RIP), enable RIP. This page is used to select the interfaces on your devices that
the following figure appears. If you are using
use RIP, and the version of the protocol used.
49
