ver.11112020-00 Page 6
3. CHECK & TEST
NOTE!
DO NOT keep LED Pucks running
continuously outside the rail as they will
overheat and may damage. Ensure test
duration is short.
NOTE!
ONLY ONE colour channel at
a time should be tested. DO NOT test
all channels at once or it may lead to
overheat.
Check and test the system outside the rail
as follows:
3.1
Ensure all plugs are connected,
including the return cable and feed cable
are connected to the driver.
3.2
Apply power to the driver.
3.3
Check that ALL the LED Pucks are
responding to the DMX / RDM. Ensure to
test only one colour channel at a time, as
LEDs can overheat outside of the rail. (Red,
Green, Blue and White)
3.4
Disconnect power and go to next step.
INSTALLATION GUIDE
3.3 Confirm LED Pucks respond to DMX / RDM input signal
INSTALLATION
LED PUCK RGBW WIRING GUIDE
LED PUCKS WILL OVERHEAT AND MAY CAUSE DAMAGE IF
KEPT RUNNING OUTSIDE THE RAIL CONTINUOUSLY.
ONLY ONE COLOUR CHANNEL AT A TIME SHOULD BE
TESTED. DO NOT TEST ALL CHANNELS AT ONCE OR IT MAY
LEAD TO OVERHEAT.
