LX1200TI User’s Guide (020-0512-01A)
17
Step 3 - Connecting the Monitor
Once the LX1200TI is mounted in place, connect it to the computer (or other
video source) and the 12 VDC power supply as follows.
1. As needed, route any data and power cables from the computer to the
monitor.
2. Make sure the computer is turned off .
3. Connect the 12 VDC power supply cable to the monitor’s power supply.
4. Connect the power supply and power interrupt cables (for the
All-in-One power switch, if your computer or docking station is so
equipped) to the connectors on the bottom of the monitor. See the
following diagram for connector locations.
Note:
This procedure refers to connections to and from the computer.
However, depending on your particular hardware confi guration, these
connections may be to a dock or other device rather than directly to
the
computer.
Note:
Use a 5-Amp fuse in line to the power source.
Also, to prevent vehicle battery from draining, you should install a
device that shuts off power to the monitor while the monitor is
inactive. (An example is Lind Electronic’s Vehicle Battery Voltage
Shutdown Timer - www.lindeletronic.com).
Dimming Dial
USB Type A
Volume Dial
Speaker Vent
USB Type A
USB Type B Upstream
VGA
Power 12 V
Audio
Remote PC Shutdown
