LA1710R, LA1710RTR , LA1710RTS and LA1710RTC User’s Guide (020-0320-03 Rev. A
)
11
Connecting the display
(Figure 1.1)
To set up this display, please refer to the following fi gure and
procedures.
1. Be sure all equipment is off .
2. Connect the DC power cord to the power connector. Plug one end of the AC
power cord into the power adapter, and the other end into an electrical
outlet(1).
3. For the PC with Analog graphics output: connect the VGA signal cable from
display VGA input connector to the 15-pin connector of your host computer
and tighten the screws(2).
4. For DVI-D output: connect DVI cable from display to the PC(2a).
5. For the LA1710RTR , LA1710RTS or the LA1710RTC touch screen models
confi gure the touch screen. Refer to the “Touch Screen Driver Installation”
section on page 25.
6. Turn on your computer, display and video source.
Notice: To ensure the LCD display works well with your computer, confi gure
the display mode of your graphic card, less than or equal to 1280
x 1024 resolution and make sure the timing of the display mode is
compatible with the LCD panel. “Video Modes” of this LCD panel are
listed in the appendices for your reference.
