Floppy Drive Connection
Please note that this is NOT a standard floppy drive connection. The Clean Screen II is not
designed for regular use with an external floppy drive. The connector will only allow use of a
Planar 3.5" external floppy drive and is intended only for diagnostic and service use. If you need
to load drivers for your operating system or other programs, you will need to obtain the correct
drive. See What if I’m missing something? in the Before You Begin section.
If this device is used in a medical facility, any operating systems or programs
used are required to be in the user’s language.
Power Supply
If you will be using AC power, you will need to use the AC power supply adapter that was packed
with your Clean Screen II. If you will be using a Planar mounting stand with batteries, you will
use its power connector. To prevent accidental power disconnect, always secure the power plug
into the jack using the attached thumb screws.
Power Cord Selection
The Clean Screen II AC power supply adapter has been provided with a “Hospital Only” or
“Hospital Grade” type cord and plug. The plug has NEMA 5-15 approval. In the event it
becomes necessary to replace the power cord, it is important to select a “Hospital Only” or
“Hospital Grade” type cord and plug.
USB Connection
The dual stacked USB port connectors are mounted on the I/O shield.
External Speakers
Speakers are supported through USB.
14
Planar Clean Screen II PC User’s Manual
CS II Manual LAYOUT#2304 3/25/99 11:16 AM Page 14
