Plamen Tena Termo, Technical Instructions

Page: 30 / 64

Remember:
Rated heating output [kW]
Flue gas flow rate (m)
Mean flue gas temperature downstream the flue connection
Minimum required negative pressure in the chimney [p] at rated output
Minimum required negative pressure in the chimney [p] at 0.8-times rated output
kW
g/s
°C
mbar
mbar
• When reloading, make sure to load a quantity of fuel that is most suitable in respect of the
actual heating requirements.
•
When reloading, make sure that the air controls on the top plate are closed.
• After reloading, open the air supply controls as required until bright fire is developed. Only
then, set the air control to the position corresponding to the desired heating output.
•
Strictly observe these installation and operating instructions, paying special attention to
setting the air controls to proper position to ensure clean (full) fuel combustion and clean glass.
•
Install the stove in a room of adequate size to ensure that the rated output of the stove meets
the heating requirements of the room.
•
Avoid stove operation at minimum output. Over the night, leave the air supply controls open to
an extent as required to maintain the ember bed until the next morning to set the new fire easily
with dry kindling.
•
When cleaning, i.e. removing the ash, make sure that sufficient ash is left to cover the
undulated ribs and the central part of the lower plate including the sliding grate and thus to
ensure long-lasting ember and to protect the lower plate.
15
16,5
12
10
288
30