Scope of delivery
Beside the PowerPac 5002 you can find following components included:
•
Mains cable with PowerCon®-male connector. Only use this cable without any manipulation on the cable itself.
Technische Daten Übersicht
Product detailed description
The PowerPac 5002 comes with two identical amplifier blocks with separate power supplies.
Thanks to the high
class operation- and protection circuits the PowerPac 5002 offers
–
beside the audiophile presence and impressive
output power of 2 x 2.500Watt
–
the well known and outstanding performance and operation reliability like the
whole PowerPac-Series from PL-AUDIO. The clear structured connection board backside offers - beside the
Speakon®-Speaker connectors (double: one connector wired on Pin 1+/1- and the other connector wired 2+/2-)
–
XLR signal pass through for signal forwarding to additional components, allowing the comfortable set-up of high-
powered multi channel systems.
5
2-CHANNEL CLASS D AMPLIFIER: 2 X 2500 W
INPUTLIMITER AND PEAKLIMITER
Inrush current limitation
Protection circuit against switching transients
Intelligent mains fuse protection
Low voltage and high voltage protection
DC
–
protection of the outputs
automatic temperatur control
Very quiet fan
High damping factor >1000 ( 8 Ohm, 1Khz)
Very low distortion factor:
THD+N less than 0,05% (20 Hz
–
20 Khz)
Signal to noise rate:
Less than 120 db (20 Hz
–
20 Khz)
Wide-range power supply with automatic voltage
detection and automatic switch 120V
–
265V
2 HE aluminium housing
Weight: just 7,3 kg
Installation depth of 410 mm
Powercon In
–
out
2 x On-/Off-Switch on the front
2 x XLR in and out
2 x Speakon out
2x 2,5 KW
modular setup and
2 separate power supplies
USER MANUAL PowerPac 5002
© PL-Audio GmbH & Co.KG | Siegener Straße 6 | 57482 Wenden | www.pl-audio.de Version: October 2021 V 1.0
