Changing the display mode
The display mode screen (indicated by a “d” on the top row, on the left side) determines
the information displayed on the top line of the register during normal operation. The
display mode may be either the totalizer screen or the flow rate screen.
“C,” indicates the totalizer screen and “F” indicates the flow rate screen. The totalizer
screen is depicted below:
1. While a letter is flashing on the display, press the RESET button to select either
totalizer or flow rate.
2. Upon completion of this setting, the programming of the industrial standard register
and the industrial dual pulse output is complete.
Exiting programming mode
To exit the programing mode:
On any screen, press and hold the both the TOTAL and RESET buttons. The screen will
revert back to the programmed scale factor, and then flash. Following the three flashes,
the register display will be blank.
NOTE:
Pressing the TOTAL or RESET buttons will turn the display back on.
DOZ03 / DOZ05 / DOZ07 Instruction manual 02/2021
page 22
