User manual - ATR121/141 -
29
10
cA.G
|
cAL.G
Gain calibration
Percentage value that is multiplied for the process value
(allows to calibrated the working point)
-19.9% .. 99.9% | -99.9% .. 99.9%
Percentage (
default
0.0)
11
ReG.
Regulation type
HEA
|
HEAT
Heating (N.A.) (Default)
co o
|
co oL
Cooling (N.C.)
m. r.
|
m. r.
Absolute alarm with manual reset
m. r. m
|
m. r. m.
Absolute alarm with manual reset and relay
status stored in case of power failure.
H. o. o
|
H. o. o
Heating with PID always to 0 if the process is
over the setpoint.
12
S. c. c.
|
S. c. c.
command state error
State of contact for command output in case of error
c. o.
|
c. o.
Open contact (
default
)
c. c.
|
c. c.
Closed contact
13
Ld1
|
Led1
command led
State of the OUT1 led corresponding to the relevant contact
c. o.
|
c. o.
ON with open contact
c. c.
|
c. c.
ON with closed contact (
default
)
14 14
HY. c
|
HYs. c
command hysteresis
Hysteresis in ON/OFF or dead band in PID
-199 .. 999 | -999 .. 999
Value expressed as degrees.tenths for temperature sensors
and digits
4
for linear sensors and potentiometers (
default
0.0)
4
The display of decimal point depends on the setting of parameter
sen.
and the parameter
d. p.
Summary of Contents for ATR 121
Page 1: ...ATR 121 141 Controller User manual...
Page 2: ......
Page 4: ...4 ATR121 141 Manuale d uso...