z
DDNS Host Name: Specify the DDNS server host name.
z
Account ID: Specify the account that is registered in the DDNS server.
z
Password: Specify the password that is registered in the DDNS server.
z
Update Time: as previous described. The default update time here is 2073600 seconds.
z
Apply: save the changes made.
Example:
To setup a network camera (IP address 192.168.0.200) behind a dialup ADSL router, and wish to access by name
http://demo.ddns.pixord.com. And, the procedure is as below:
1. Configure the ADSL router with PPPoE enable, assume the IP of the router is 192.168.0.254, and subnet
mask is 255.255.255.0
2.
Go into "Virtual Server" or "Port Forwarding" configuration page in the ADSL router, set Port 80 to
server IP 192.168.0.200
3. In Network Settings > General page of the network camera, configure the settings with IP address
192.168.0.200; subnet 255.255.255.0; DNS1 with valid DNS address such as 168.95.192.1 or 168.95.1.1;
gateway IP address with 192.168.0.254 (router’s IP); HTTP port with port 80.
4. Configure the Device Name with “demo”.
5. Configure Dynamic DNS Settings with Enabled; DDNS Server Address with “ddns.pixord.com”; DDNS
Connection Port with port 80; Router Incoming Port with 80; and Update Time with 600 (10 minutes). Finally,
clicks [Apply] button.
6. If DDNS message success, then enter URL http://demo.ddns.pixord.com on browser. Consequentially, it will
show the home page of the network camera.
- 38 -
