- 41 -
- 42 -
The FEC and other settings that set on the master unit will also be appeared on the slave unit automatically. The
slave unit does not need any operation. Use the following settings to make wireless flashes according to the same
methods with normal flash shooting.
●
Flash Exposure Compensation (
/
Page 35)
●
High-Speed Sync
(
/
Page 36)
SYNC
Use two or more master units. By preparing several cameras that with master units flash attached, cameras can be
changed in shooting while keeping the same lighting source (slave unit).
Using Fully Automatic Wireless Flash
About Master Unit
Check that the flash is ready.
5
●
Check that the master flash
ready indicator is lightened.
●
When the slave flash ready
indicator is ready, the AF-
assist beam lighting area will
blinks at 1 second intervals.
4. i-TTL
：
Fully Automatic Wireless Flash Shooting
Using Automatic Wireless Flash with a Single Slave Unit
Master Unit Setting
1
●
Attach a
HYBRID360
ITTL
camera
flash on the camera and set it
as the master Unit. (Page 40)
●
M/A/B/C can be set as TTL
mode independently.
Check the flash operation.
6
●
Press the master unit's Test
Button< >.
●
Then, the slave unit will fire.
If not, adjust the slave unit's
angle toward the master unit
and distance from the master
unit.
Wireless Flash: Optic Transmission
Slave Unit Setting
2
●
Set the other
HYBRID360
ITTL
as
the wireless slave unit. (Page
40)
●
The slave unit can be set as
A/B/C.
Check the communication
3
channel.
●
If the master unit and slave
unit(s) are set to a different
channel, set them to the
same channel. (Page 4
1
)
Position the camera and
4
flashes.
●
Position the camera and
flashes as the picture shows.
(Page 39)
The slave unit might be out of order or fire an unwanted flash due to the nearby fluorescent lamp or computer screen.
●
If the slave unit's auto power off function is workable, press the master unit's test button to power it on. Please note
that test firing is unavailable during the camera’s regular metering time.
●
By making some settings, the auto AF-assist transmitter will not blink after the slave unit's flash ready indicator is
lightened. (C.Fn-AF/ Page
47)
Wireless Flash: Optic Transmission
5. M: Wireless Flash Shooting with Manual Flash
This describes wireless (multiple shooting) using manual flash. You can shoot with a different flash output setting for
each slave unit (firing group). Set all parameters on the master unit.
Setting the flash mode to
1
<M>.
●
Press Function Button 4
<
> to choose groups.
Then, press Function Button
3 <
MODE
>to set the flash to
M mode.
Setting flash output.
2
●
Press Function Button 2
<
>.Turn the Select
Dial to set the flash output of
the groups. Press the <
SET
>
button to confirm.
Gr
Taking the picture.
3
Each group fires at the set flash
ratio.
6
、
RPT: Wireless Flash Shooting with Manual Flash
Setting <RPT> stroboscopic flash.
●
Press <
MODE
> button so that
<
RPT
> is displayed.
● Setting the stroboscopic flash. (Page
38)
The firing frequency of stroboscopic flash during the optic transmission wireless shooting can be set from 1Hz to
100Hz.
