- 39 -
- 40 -
This product is compatible with Nikon Creative Lighting System (CLS). It can function as either an optic
wireless master or slave flash. As a master unit, it can control Nikon speedlights e.g. SB-900 and SB-910
via wireless. As a slave unit, it can be controlled by wireless signals of Nikon speedlights e.g. SB-900 and
pop-up flash commanders of Nikon cameras e.g. D7100/D7000/D800.
●
You can set up three slave groups for i-TTL autoflash shooting. With i-TTL autoflash, you can easily create
various lighting effects.
●
Any flash settings for the slave units on the master flash in i-TTL/Manual/RPT mode will be automatically sent to
the slave units. So the only thing you need to do is to set the master unit for each slave group without any
operation for the slave units at all during the shooting.
●
This flash can work in i-TTL/M/RPT/OFF flash modes when set as a master unit.
Positioning and Operation Range
1
.
Wireless Settings
You can switch between normal flash and wireless flash. For normal flash shooting, be sure to set the wireless
setting to OFF.
Indoors
Outdoors
15
m
(
49
.
2
ft
)
10
m
(
32
.
8
ft
)
80°
8
m
(
26
.
2
ft
)
12
m
(
39
.
4
ft
)
Wireless Flash: Optic Transmission
●
Even with multiple slave units, the master unit can control all of them via wireless.
●
In this user manual, "master unit" refers to the camera flash on a camera and "slave unit" will be controlled by the
Press <
> button so that
<
>
or
<
RPT
>
are displayed on the LCD panel.
The backlight of LCD panel turns green now.
Master Unit Setting
Slave Unit Setting
Press <
> button again
so that
<
>
or
< >
are displayed on the LCD panel.
The backlight of LCD panel turns orange now.
2
.
Setting Master Unit's Flash Mode
Press Function Button 4
1
<
> to choose the group
from M/A/B/C. Then, press
Function Button 3 <
>
so that the master unit can
work in
OFF/i-TTL/M
flash
mode. Choose one of them as
the flash mode of master unit.
3
.
Setting the Communication Channel
If there are other wireless flash systems nearby, you can change the channel IDs to prevent signal interference. The
channel IDs of the master unit and the slave unit(s) must be set to the same.
Press Function Button 3
1
<
> and turn the Select
Dial to choose a channel ID
from 1 to 4.
Press the <
SET
> button to
2
confirm.
CH
Press the "MODE/Lock" button
2
can change to RPT mode.
Wireless Flash: Optic Transmission
MODE
