- 33 -
- 34 -
Name of Parts
Installing Reflector (Other Accessories)
1
.
Rotate Accessory Locking Ring
ounter-clockwise until it is loosen.
2
.
Insert the reflector into the Accessory
Mount.
3
.
Rotate Accessory Locking Ring
clockwise to lock it up. Do not
over-tighten.
Attaching Flash Tube
1
.
Remove the reflector or other
accessories from the flash head.
2
.
Match the red dot on the base of the flash tube with the red dot in the Tube
Socket. Push the flash tube in until it is securely seated into the socket.
1
. Before connecting, make sure that
the power pack is turned off.
2. Plug one end of Power Cable into
Power Socket of the flash unit, and
insert the other end into the output
socket of the power pack.
3
.
Turn on the power pack. Normally
the flash unit will be fully charged
and ready to work.
The flash unit is not powered by itself, but draws power from
PIXAPRO
power pack
PowerPack Dual Output
(sold separately).
For the instructions of the power pack, see the related user manual.
Connecting to a PowerPack
Name of Parts
Connecting the Flash to a Camera
1. Loosen the locking ring on the
mounting foot.
2. Slip the mounting foot of the flash
unit into the camera hotshoe.
3. Secure the flash unit by rotating the
locking ring the direction of the row.
The off-camera adapter is useful when using the product as an off-camera
flash. There is a 1/4" mounting hole at the bottom of the off-camera
adapter. After replacing the adapter, the flash can be used mounting on
PIXAPRO
PortableHandheld
boom,
600
floor stand, and almost any other
light stand. To install the off-camera adapter,
1. Use a screwdriver (not included) to
remove the four screws at the bottom
of this product. Then take out the
bottom part carefully as illustrated.
2. Install the off-camera adapter at the
bottom of this product.
3. Tighten all the screws.
Replacing the Off-Camera Adapter
Power Management
ON/OFF Power Switch controls the on/off of the flash unit. Turn off the power pack if the flash unit will not be used
for an extended period (approx. 1 hour).
Disabling Auto Power Off function is recommended when the flash is used off camera. (C.Fn-APO, Page 47)
C.Fn
