Movie Length
Switch 7 sets the length of the movie captured.
15 second movie 20 second movie
Control LED On/Off Setting
Switch 8 sets if the Control LED (
Red LED
) is to be used or not. Note, the control LED will
always be on during the Power-Up Phase, or when in Walk-Test Mode.
Control LED On Control LED Off
PIR LED On/Off Setting
Switch 9 sets if the PIR LED (
Green LED
) is to be used or not.
PIR LED On PIR LED Off
Note:
When changing switch setting you must re-boot your DigitalEye board.
When re-booting you must wait approximately 30 seconds before turning
power on again. Not doing so can result in the controller not working
properly. Symptoms of this are a dim red LED or blinking green LED, or
both.
