Putting the DigitalEye™ Out in the Woods…
Before setting your DigitalEye unit out in the woods be sure to
read over the previous sections. Be sure to setup your User
Switch Setting to the desired mode of operation.
The default mode is 10 seconds between photos (PIR delay),
24 hour photo taking mode, digital still photo taking mode, Red
Control LED On, Green PIR LED On.
Find a secure tree or post to mount your DigitalEye unit to in
the woods. See the “Setup Tips” for more information on
placing the unit in the woods.
Once the DigitalEye unit is powered up the Red and Green
LED’s will turn on. You have a total of 2 minutes to hang the
unit before the DigitalEye will start taking photos. The Green
PIR LED will shut off after about 20 seconds and will blink
every time it sees motion. The Red Control LED will stay lit the
entire 2-minute time period, then turn off. The Red Control
LED will still light even if the User Switch Setting for this LED is
turned off, however, if the User Switch Setting for the Green
PIR LED is turned off the LED will not light.
Note: When hanging your DigitalEye on a tree keep it
about 2.5 feet to 3 feet above the ground. This will give
you the optimal detection range.
Setting up the DS-06
1. Turn the unit power switch on by turning the switch up.
2. Close the lid
