2
START
ENGINE
STOP
Size
[Unit
：
mm]
ø60
15 30
70
50
Depth
22
Unit
Meter
ø65
Notes about using the OBD Connector
If you unable to get a grip
on the distended portions.
M a k e s u r e t o g r i p t h e
distended portions when
pulling it out or inserting it.
D o n o t p u l l o n t h e w i r e s
when trying to remove the
connector; the wires may
become disconnected.
CAUTION
W i t h s o m e c a r m o d e l s i t
m ay b e d i f f i c u l t t o g e t a
good grip on the connector.
In such case, pull
out the connector
by p u l l i n g o n t h e
end of the zip tie.
[ Unit ]
(View from Gauge Connection)
(View from Car Connection)
7
10
Meter connector
Connect gauge cable
8
Boost connector
Connect Boost sensor
(sold separately)
9
Power connector
Connect OBD cable
7
8
9 10
Oil Temp connector
Connect Oil Temp sensor
(sold separately)
①
②
①
By the accelerator pedal
②
At the right foot of the driver
seat (with lid)
Connecting The Wires
③
Affix the
Cushion Tape
to the base of the meter, connect the Gauge Cable to the
Meter, and install the Meter into the Meter Holder.
Please add the Cushion Tape
if the Meter not fixed.
①
Fa s t e n u s i n g t h e
double-sided tape.
N ote : Please be sure ab out
where you wish to install the
meter, as it is not advisable to
reuse double-sided tape.
Meter Holder
Gauge
Cable
Back side
of Meter
Clean
to remove
oil and dust
Double-sided
tape
②
After deciding the position
and angle of the meter face,
fasten the Hexagonal bolt
on both sides to secure.
Connector
Cushion Tape
Cushion Tape
Cushion Tape
Hexagonal bolt
A Installation with the Meter Holder
Installing The Product
Installing The Meter
Gauge
Cable
Cut the Cushion Tape in half, affix to base of the Meter to be on press
fit condition with adjusting number. And connect the Gauge Cable to
the Meter and insert into the panel.
Cushion Tape
Cushion Tape
B Installation to panel or something
C Installation to A-pillar using A-pillar Stand
Panel
Cut the Cushion
Tape in half
Make a ø5 hole on the place to install the meter of the A-pillar, and fix the
Meter using A-pillar Stand with Screw and Nut.
A-pillar
Screw
Nut
A-pillar
Stand
ø5 Hole
A-pillar
Placement Diagram for
Diagnostic Monitoring Connector
Unit
4-pin
Connector
Meter
Holder
6-pin
Connector
5-pin
Connector
Backside
of the
meter
Diagnostic
Monitoring
Connector
(1.5 m)
(0.5 m)
②
①
④
④
③
Engine
Start
①
Engine Start.
②
Insert the OBD Connector to the Diagnostic Monitoring
Connector.
③
Insert the 4-pin Connector to the backside of the meter.
④
Insert the 5-pin Connector of Gauge Cable and 6-pin
Connector from the Power Cable to the Unit.
If the meter not activate from individual differences in car models
or some reasons after the engine starts, you need to change the
power source and connect the power cable to IGN.
⇒
See Separate sheet
【
Connect the power cable to IGN
】
.
