28
M0217 EN
EN
L3
DUTY CYCLE
NOTE
The pumps have been designed for intermittent use and
a duty cycle of 30 min. ON and 60 min. OFF in conditions of
maximum A. TEMPERATURE (40 °C) AND AT NOMINAL TRANS-
FER CONDITIONS.
ATTENTION
Functioning under by-pass conditions is only allowed for
short periods of time (max. 3 minutes).
L.4 FLUIDS PERMITTED
ATTENTION
THE PUMP CAN BE UESED ONLY WITH THE FOLLOWING FLU-
IDS:
- DIESEL - KEROSENE
- PETROL - PETROL ALCOHOL MIXED MAX 15%
M INSTALLATION
ATTENTION
BEFORE ANY OPERATION, ENSURE TO BE OUT OF
POTENTIALLY EXPLOSIVE AREAS
The pump must never be operated before the delivery and
suction lines have been connected.
TIGHTEN THE ELECTRICAL BOX TO ENSURE PROTECTION
AGAINST THE RISK OF EXPLOSION
THE RIGHT CLAMPING SCREWS COUPLE THAT GRANTS THIS
PROTECTION IS 10Nm
PRELIMINARY
INSPECTION
- Verify that all components are present. Request any missing parts
from the manufacturer.
- Check that the pump has not suffered any damage during transport
or storage.
- Carefully clean the suction and delivery inlets and outlets, removing
any dust or other packaging material that may be present.
- Check that the electrical data corresponds to those indicated on the
data plate.
- Install the pump at a height of min. 80 cm.
ATTENTION
IF VALVES IN THE CIRCUIT ARE TO BE INSTALLED, MAKE
SURE THEY ARE EQUIPPED WITH OVERPRESSURE SYSTEM.
CLEAN THE TANK AND MAKE SURE IT IS WELL-
VENTILATED (RECOMMENDED OPENING
PRESSURE: 3 psi)
APPLY THE QUICK COUPLING TO THE TANK CORRECTLY
AND SAFELY
ATTENTION
DO NOT BLOCK THE DRAINAGE HOLES
