Page 9
For technical questions, please call 1-800-444-3353.
Item 60805
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical outlet
before performing any inspection, maintenance, or cleaning procedures.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1.
BEFORE EAcH USE,
inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
2.
AFTER USE,
wipe external surfaces
of the tool with clean cloth.
3.
WARNING! If the supply cord
of this power tool is damaged,
it must be replaced only by a
qualified service technician.
Troubleshooting
problem
possible causes
Likely Solutions
Tool will not start. 1. Cord not connected.
2. No power at outlet.
3. Internal damage
or wear.
(Carbon brushes or
switch, for example.)
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker.
If breaker is tripped, make sure circuit is right
capacity for tool and circuit has no other loads.
3. Have technician service tool.
Tool operates
slowly or
overheats.
Extension cord too long
or wire size too small.
Eliminate use of extension cord.
If an extension cord is needed, use shorter/
heavier gauge cord. See
Extension Cords
in
Grounding
section on page 5.
Excessive noise
or rattling.
Internal damage or wear.
(Carbon brushes or
bearings, for example.)
Have technician service tool.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Summary of Contents for 3 CFM two stage
Page 1: ......
