6
SunZoon Light User Guide 59022 V0513
17. Hold the motor so the shaft and gear are facing the same
side as the drive gear. Mesh the two gears together so they
work together but are not pushed together too tightly.
When the motor is positioned so the gears work together,
push the motor onto the adhesive tabs.
18. Place two adhesive tabs on back of the solar panel – one just
under the wires and the other on the opposite end hanging
over the edge just a little. Peel the paper backing off the
adhesive tabs. Press the solar panel onto the body and
motor so the wire end is near the motor and the solar panel
angles toward the front of the chassis (Figure 3).
Your SunZoon Lite is finished! Take it outside on a bright, sunny
day and race it on a smooth, level surface.
Tip: If the motor seems “sticky,” you need to prime it. To do this,
use a nine-volt battery (not included). Unclip the wires from the
motor and hold the two connection points of the battery to the
two motor connection terminals (it doesn’t matter which sides
of the battery touch which sides of the motor). Run the motor in
this manner for no more than five seconds. Then, reclip the wires
to the motor – the motor should run more smoothly.
Figure 3
