SunZoon Light User Guide 59022 V0513
13. Place the other axle into
one of the front wheels.
Follow with a spacer
and then push the axle
through the two front
screw eyes. Follow with
another spacer and the
other front wheel (Figure
2). Again, make sure the
parts are not too tight.
If any of the wheels rub
against the chassis, cut
slightly longer spacers
and replace the old
spacers.
14. Flip over the car so the
wheels are on bottom.
Detach Gear G or N
(20-tooth, 2-millimeter
bore) from the gear font.
This is the pinion gear. Cut
off any flashing. Push the
pinion gear onto the motor shaft.
15. One of the motor connection terminals will have a small
dot by it. This is the negative side. Clip the solar panel black
wire to this side. Clip the red wire to the other connection
terminal.
16. Place two adhesive tabs so they line up between the rear
wheels and are centered over the back axle. Peel the paper
backing off the tabs.
Figure 2
