Pitney Bowes Epic v3.1, Operator'S Manual

Page: 49 / 336

Disabling (and Enabling) the Inserter
When you are logged in as an Operator, you can disable the inserter from any run activity. Typically, you
might only disable the system if directed by Service.
For example, if Service needs to perform diagnostic activity on the machine, they may ask you to disable
the system, to avoid having to completely shut down. This freezes system activity, preserving data that
may be helpful for diagnosing issues.
When you are ready to start running the job again, you can enable the system.
1. Click the Menu button on the bottom of the main DC screen, near the Start bar at the bottom of the
screen.
2. Select Disable System . The inserter stops and cannot be started until it's enabled through DC.
3. When you are ready to run the inserter, click the Menu button and select Enable System . The
inserter is enable to start when you are ready.
Using Direct Connect
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 42 of 328