11
Operation
Step # Description
Action
Notes
1
Disable stacker
motion.
Press and hold down "Straight/offset
stacking" for more than two (2)
seconds.
For handling of
extreme light weight
papers.
2
Reinstate stacker
motion.
Press and release "Straight/offset
stacking".
Step # Description
Action
Notes
1
Enter speed
adjustment mode.
Press and hold "Selection
programming mode" for more than two
(2) seconds.
The last bin LED
lights and counter
display shows speed
in sets/h :10
2
Select collating
speed.
Press "Selection programming mode". The counter will
display the speed in
sets/h :10
3
Confirm adjustment. Press and hold "Selection
programming mode" for more than two
(2) seconds (the bin LED will go out).
The counter will now
display the counter
value.
Step # Description
Action
Notes
1
Isolate defective bin
sensors and
disengage these
bins.
Press and hold "Test and calibration"
for more than five (5) seconds.
The electronics check
all bin sensors and
disengages the bins
with defective sensors.
2
Re-engage bins after
correction of the
problem.
Press and hold "Test and calibration"
for more than five (5) seconds.
*
This process can also be used to disengage bins with other problems. In this
case the feed roller shaft is removed and a sheet inserted (80 gsm or heavier) in
the bin to cover the bin sensor (simulating a defective sensor). Pressing “Test/
calibration” for more than five (5) seconds will now disengage this bin.
4.9 Disabling stacker motion
4.10 Collator speed adjustment
4.11 Disengaging bins with defective sensors*
