Pitco Solstice SE Series, Service Manual, Page: 30 / 72

Pitco Solstice Electric Fryers
SE Series Service Manual 30
Replacing the Hi ‐ Limit
1. Remove the two (2) screws on the hi-limit clamp
using a Phillips screwdriver.
2. Remove the clamps.
3. Remove the hi-limit using a 7/8 inch socket.
4. Cut the probe wires at the termination end
connected to the entrance box wire channel.
5. Pull the hi-limit and wires through the tank
fitting.
6. Slide the wires of new hi-limit through the tank
fitting and install a new hi-limit cartridge.
7. Install the hi-limit wires into the connector (pins
1 and 2) and fasten the connector to the wire
channel.
NOTE: Use the appropriate set of
connections on the wire channel.
Full
Split
8. Follow steps 1 through 3 in reverse to finish the
replacement of the hi-limit.
Right
Tank
Left
Tank
Doors