Pitco ME14S-C/MFD, Service Manual

Page: 14 / 38

10
Pivot the front panel down and allow the computer
to be supported on the mounting tabs.
Unplug the computer/controller wiring harness. The
front panel can now be removed by pulling the com-
plete assemby forward.
Remove the lower cover by removing the 2 screws
located in the bottom of the cover.
All of the components mounted in the front panel
can now be accessed through the opening.
Heat Demand Relays:
Mounted on the rear brace of each fryer unit you will
find the Heat Demand Relay housing. Remove the
cover of the housing from the front of the machine.
The Relays can now be seen from the front, they are
mounted to the Heat Sink using 2 screws. Terminals
1 & 2 are the load connections and terminals 3 & 4
are the 24VAC input terminals.
Circuit Breaker:
Remove the mounting screws on either side of the
cover. Turn the cover over and the circuit breaker
can be removed from the cover.
Hood & Filter Relays:
These relays are always wired in the following man-
ner -