system’s Arm or Disarm status. This is recommended to be used for smoke detector, panic button, water leak sensor and temperature
sensors only. DONOT set any door sensor or motion sensor as Emergency zone
).
Home Zone
Highlight it press Enter, Default is YES, (
if you select NO, the zone will disable during home alarm status,
recommended for motion sensor NO, and all Window/door sensor YES
)
Chime Zone
Highlight it press Enter, Default is NO,(
This function not work with motion sensor
)
Delayed Zone
Highlight it press Enter, Default is NO, (
if set YES, allows you to come back home and open the door without
triggering the system. System default delay alarm time is 45 seconds. You can change this time by going to "System Settings" and set
the Alarm Delay time
).
Siren Enable
Highlight it press Enter, Default is YES, (
if set NO, siren will disable when this zone triggered, no siren alarm will
sound.
)
Note:
All zones are instant zones by Default
.(“
Instant “refers to the system being immediately armed if any zone is triggered
when the system is in armed status
.)
Delete
select it then press Enter, you can find the target sensor and delete it,
Test the Motion Sensor
The Motion Sensor will initialize itself during the first 1-3 minutes after the front cover is re-attached
（
DO NOT KEEP Cover
open
）
. Do not test it during initialization. You can walk 3-5 steps in front of motion sensors after initialization, the LED will
remain on for 3 seconds when motion is detected until the Motion Sensor short blinks once again before resuming motion
detection for next detector.
1. Move away from the area that is in direct line of sight of the Motion Sensor (move to an adjacent room). Waiting 2-3
minutes until the LED stops blinking.
2. Move back into the line of sight of the Motion Sensor, walk around 3-5 steps. (this will trigger the main console).
If the Motion Sensor test is successful the LCD screen will display " xxx Sensor Alarm". If these words do not appear, either (A)
the 20-second waiting period since the last trigger has not expired, or (B) the Motion Sensor is not in communication with the
PiSECTOR system main console.
If you want to re-start the initialization again, open the Front Cover and remove battery waiting for 5 seconds then re-install it
again, as shown in Figure 1 and then re-attach the Front Cover.
Note1:
For saving battery power, motion sensor may be insensitive if you active it more than three times in a few minutes. Please leave the
detectable area for a few minutes and come back, it will detect you again.
Note2:
Motion sensor may be insensitive or give a lot false alarms if the temperature is more than 98F (37C).
Mount Motion Sensor
D. Place the motion sensors in the following
location recommendations (check
marked locations) shown in Figure C.
Avoid the example location marked with
the "
X
" which are household areas that
typically cause false alarms, such as heat,
air conditioning, fans, or direct sunlight.
The recommended mounting height is
6.5-7.0 feet for both coverage and pet
immunity purposes.
E. Apply the 3M adhesive tape in the locations shown in Figure D for corner mounting or wall mounting (
apply for super
glue on the surface of window or wall before stick 3M adhesive tape to void any falling
).
If you prefer to use screws to mount the motion sensor, follow the screw position shown in Figure E (optional)
