Connect the regular telephone device to TEL port on
back of console. Route the phone cord through the
channel toward the side of the console (if you have no
landline, you can use OBi110/ MagicJack / Vonage /
Ooma VoIP service to connect your internet Router /
Modem then connect console to the VoIP device ) if you
use landline, priority call by landline, then GSM SIM
card.
Note:
If you use only landline, you cannot dial out
through main console direct, you need use your home
phone to dial out or receiving call, system will auto dial
out if alarming, but if you use GSM SIM card, you can
use the main base as telephone, you are able to dial out or receive call from main base directly.
Connect the power adapter to POWER port on back of console
Route the
power adapter ( 12V 1A )
cord through the channel toward the side of the console
Plug the power adapter into nearby electrical wall outlet that is not controlled by a switch
Keep the Battery Switch at ON position for internal battery backup charging
.
Wired Port - Function interface of the main unit
1
GND
Ground
2
Z3
Wired sensor 1: support both NO and NC (Auto create Zone 49)
3
GND
Ground
4
Z4
Wired sensor 2: support both NO and NC (Auto create Zone 50)
5
GND
Ground
6
+12V
DC 12V Positive Wired in
Keychain Remote
Press
to Arm /
Activate your system as Away from home
Press
to Disarm/ D
eactivate your system
when you come back home
Press
to Home arm /A
ctive your system as Stay Home( if you go to Sensor-Edit and set part
of sensors for Home zone as No, when you press Home, that sensor will disable, and all other
sensors still enable)
Press
this key you will see icon
on LCD screen, that means you have enabled your Chime
function, ( to make it work if you go to Sensor-Edit and set your door sensor for Chime zone as
Yes, you will hear a music bell sounds when you open your door), press
once to enable, press
once again to disable.
Press
once for "silent emergency
alarm mode”. This allows you to call for help silently when someone threatens your life
without triggering the siren and alerting the invader. If you press and hold for 3 seconds, the siren will start sounding loudly in
emergency alarm mode.
Program Remote Keychain:
If you received a pre-Programed system kit, please ignore this step and do not program it again.
Press
PROGRAM
button on console, enter the default password
888 888.
Select
Remote Controllers
then press
Enter
on console you will see below list.
Add
Select Add press
Enter
, then you will see
Trigger Controller Code,
press any button on your remote Keychain. Nine
digits will appear on console screen for 1-2 seconds. This is the unique address for this keychain. The console will
